The kinematic body stops at the beginning of the ramp and cannot move anymore in any direction

Tudor

Hello! In my project, the player, which is a kinematic body, stops at the beginning of the ramp and cannot move anymore in any direction. I have set the gravity, so there shouldn't be any problems. What should I do in this case?

totoro

I'm not sure this is your solution, however I tend to have a similar issue at greater speeds, so I'm guessing it's to do with interpolating the step. So, try slowing down and see if it overcomes the issue?

Here's a couple of videos on handling steps, bumps and slopes

Tudor

Yes, I have watched these tutorials. They have helped me a lot. Actually, I solved this bug by removing the ramp, and creating a new one. I can't figure out what happened with the previous ramp.

Tudor

Regarding these tutorials, I have encountered anther issue with the sliding down the slope. Even if I followed the instructions, my kinematic body continues to slide down, even if very slowly, but it continues.

Tudor

I tried an alternative solution: the "stop_on_slope" parameter of the the "move_and_slide" function. It works somewhat, because it stops after around 5 seconds. But this is not quite the desirable result. @totoro, have you encountered this issue?